4A0-108 : Alcatel-Lucent Multicast Protocols Exam

4A0-108 Dumps
4A0-108 Braindumps
4A0-108 Real Questions
4A0-108 Practice Test
4A0-108 Actual Questions


Alcatel-Lucent
4A0-108
Alcatel-Lucent Multicast Protocols
https://killexams.com/pass4sure/exam-detail/4A0-108
Answer: A
QUESTION: 78
How many bits of the IPv4 multicast address directly match bits in the multicast
MAC address?
A. 23
B. 25
C. 27
D. 28
Answer: A
QUESTION: 79
What is the destination address of the MLDv2 report message?
A. FF02::1
B. FF02::2
C. FF02::16
D. The specific multicast group address that the host is interested in.
Answer: C
QUESTION: 80
Click the exhibit.

The interface's IGP metric is as shown, and PIM is using the unicast table for the
RPF- check. What happens when Router B receives a register message on its
interface facing Router A?
A. Router B discards the register message, as the RPF-check fails.
B. Router B forwards the register message to Router D (RP) according to its routing
table.
C. Router B forwards the register message out of all the interfaces in its
(',239.1.1.1) entry's outgoing interface list.
D. Router B forwards the register message out of all the interfaces in its
(192.168.1.1,239.1.1.1) entry's outgoing interface list.
Answer: B
QUESTION: 81
How many types of Auto-Discovery routes are defined for MCAST-VPN NLRI?
A. 3
B. 5
C. 7
D. 9
Answer: C
QUESTION: 82
What is the default version of IGMP on the Alcatel-Lucent 7750 SR?
A. Version 1
B. Version 2
C. Version 3
D. There is no default setting, you must configure the version when you enable
IGMP on 7750 SR
Answer: C
QUESTION: 83
Click the exhibit.

The network administrator of 2001 ;DB8:FEED::/64 wants to embed an RP for the
network. The RP's address is 2001:DB8:FEED::7. Which of the following multicast
address ranges would suit this purpose? (The exhibit shows the group-to-RP
mapping for your reference only.)
A. FF7x:730:2001:DBS:FEED::/96 (x is scope)
B. FF7x:730:2001:DBS:FEED::/80 (x is scope)
C. FF7x: 740:2001:DB8:FEED::/96 (x is scope)
D. FF7x:740:2001:DB8:FEED::/80(x is scope)
Answer: C
QUESTION: 84
Click the exhibit.

Based on the output, which of the following is correct?
A. The S-PMSI group address is 239.1.1.10.
B. The I-PMSI group address is 239.1.1.10.
C. The S-PMSI group address is 239.1.1.20.
D. The I-PMSI group address is 239.1.1.20.
Answer: C
QUESTION: 85
Which of the following is NOT a benefit of multicast for delivering data to multiple
receivers?
A. Its data delivery is more efficient than unicast and broadcast.
B. It is more scalable than unicast and broadcast.
C. It suits VoD (Video on Demand) services very well.
D. It suits BTV (Broadcast TV) services very well.
Answer: C
QUESTION: 86
In Draft Rosen, a PE router encapsulates customer multicast packets into provider
packets. What source IP address is used for the provider packets?
A. The system IP address of the originating PE router.
B. The source IP address of the customer packet.
C. The outgoing interface IP address of the originating PE router.
D. The source IP address specified in the MVPN configuration.
Answer: A
QUESTION: 87
What is the advantage of using the S-PMSI over the I-PMSI in Draft Rosen?
A. The S-PMSI reduces control plane overhead because the I-PMSI is no longer
needed.
B. The S-PMSI only forwards customer multicast traffic to PEs that have interested
receivers.
C. The S-PMSI is required because it is the initial multicast distribution tree for the
MVPN.
D. The S-PMSI encapsulates customer multicast traffic in an MPLS tunnel, which
is more efficient than the GRE tunnel used by the I-PMSI.
Answer: B
QUESTION: 88
Which of the following regarding VRF Route Import extended community is
TRUE?
A. It is used to support UMH selection in Inter-AS MVPN.
B. It is a new extended community added only to MVPN multicast routes.
C. It contains Global Administrator and Local Administrator fields.
D. It contains the AS number of the source PE.
Answer: C
QUESTION: 89
A BSR candidate message is seen with a higher priority than the existing BSR.
Which of the following describes the action that occurs?
A. The higher priority router becomes the BSR only after the existing BSR fails.
B. The higher priority router becomes the BSR after the bootstrap message wait
interval.
C. The higher priority router becomes the BSR immediately.
D. There is a BSR configuration parameter that determines whether or not there is a
BSR election in this case.
Answer: C
QUESTION: 90
Which of the following is NOT an advantage of NG MVPN over Draft Rosen?
A. MP-BGP is more scalable than PIM.
B. Unicast and multicast traffic in the same VPRN service can use the same
transport tunnel.
C. P routers in the core do not need to maintain any PIM group states.
D. An MPLS tunnel can be used instead of a GRE tunnel.
Answer: D
QUESTION: 91
Click the exhibit.


According to the display in the exhibit, which of the following statements is TRUE?
A. The S-PMSI is instantiated by MPLS tunnels.
B. The S-PMSI group address range is 232.10.10.0/24.
C. 192.168.1.2 is the system IP address of the source PE.
D. The customer is sending multicast traffic to group 239.1.1.1.
Answer: D
QUESTION: 92
Which of the following services is provided by the use of PIM as a multicast
routing protocol?
A. Authentication
B. Guaranteed delivery
C. Device security
D. Prevention of forwarding loops
E. Prevention of Denial of Service attacks
Answer: D
QUESTION: 93
Click the exhibit.

What happens when the displayed router receives an IGMPv3 exclude none report
for group 232.1.1.1?
A. The router propagates a (:,:, 232.1.1.1) join towards RP if it exists.
B. The router sends a PIM (S, G) join toward both sources: 192.168.1.1 and
192.168.1.2.
C. The IGMPv3 report is dropped and a misconfiguration message is generated in
log 99.
D. The router sends a PIM (192.168.1.1, 232.1.1.1) join toward the source.
Answer: D
QUESTION: 94
Which of the following regarding the BSR and the RP is TRUE?
A. A router cannot be configured as a BSR-candidate and a static RP at the same
time.
B. A router cannot be a candidate-RP and a BSR-candidate at the same time.
C. There is only one active RP in a multicast routing domain at any time.
D. There is only one elected BSR in a multicast routing domain at any time.
Answer: D
QUESTION: 95
The Draft-Rosen S-PMSI address range is configured for 32 group addresses. What
happens if there are more than 32 customer multicast flows that exceed the
threshold configured for the MVPN?
A. Traffic for the 33rd multicast flow is dropped.
B. Traffic for the 33rd multicast flow is transmitted on the I-PMSI.
C. The source PE reassigns the S-PMSI with the smallest flow to the new multicast
flow. Traffic for the smaller flow is transmitted on the I-PMSI.
D. The source PE re-uses an S-PMSI that is currently in use for the 33rd flow.
Traffic for both flows is sent on the same S-PMSI.
Answer: D
QUESTION: 96
Which of the following is NOT a characteristic of Draft Rosen?
A. PIM in the VRF.
B. PIM in the service provider's core network.
C. GRE encapsulation for multicast data traffic.
D. MPLS encapsulation for multicast data traffic.
Answer: D
QUESTION: 97
Which protocol is used to establish the I-PMSI in Draft Rosen?
A. PIM DM
B. PIM ASM
C. PIM SSM
D. Either PIM ASM or PIM SSM
Answer: B

User: Sidor***** Initially, I struggled to understand the complex topics while preparing for the 4A0-108 exam using extensive study materials. However, a recommendation to try the practice tests from Killexams.com proved to be a game-changer. Using their resources, I was able to quickly memorize the key information and confidently answer 67 questions in only 76 minutes, achieving an impressive 85% score. I am grateful to Killexams.com for making my preparation so effective.

User: Irene***** Thanks to Killexams.com’s up-to-date practice tests, I passed the 4A0-108 exam with top scores. Their real exam questions were identical to the test, making preparation straightforward. Avoid unreliable sources—trust Killexams.

User: Nadezhda***** Killexams.com is simply outstanding. I scored 100% on the 4a0-108 exam using their questions and answers. The exam simulator was so effective that I felt completely prepared before even stepping into the testing center. This is the best investment I made for my certification journey.

User: Mika***** Passing the 4a0-108 exam was crucial for my career, and killexams.com’s question answers and exam simulator made it possible. Their great work helped me achieve certification and advance professionally.

User: Emiliano***** Choosing the right study material for the 4a0-108 certification was overwhelming, and I initially doubted my ability to succeed. Killexams.com transformed my mindset with their comprehensive preparation tools. Thanks to their support, I not only passed the exam but also gained the confidence I needed. This achievement has opened new opportunities for me, and I am deeply thankful.

---