Certification Practice Test | PDF Questions | Actual Questions | Test Engine | Pass4Sure
E20-555 : silon Solutions and Design Specialist for Technology Architects Exam

DELL-EMC E20-555 Questions & Answers
Full Version: 380 Q&A
E20-555 Dumps
E20-555 Braindumps E20-555 Real Questions E20-555 Practice Test
E20-555 Actual Questions
killexams.com DELL-EMC E20-555
silon Solutions and Design Specialist for Technology Architects
https://killexams.com/pass4sure/exam-detail/E20-555
QUESTION: 146
An Isilon customer has a replication policy setup between a primary cluster and a secondary cluster. After the initial synchronization of the clusters, the primary cluster starts to exhibit issues so the customer initiates a failover operation between the two clusters. During the failover, the primary cluster becomes fully operational again. The customer would like to stop the failover operation between the two clusters. What is the best way to stop the failover operation and continue using the primary cluster?
Initiate a failover revert on the secondary cluster
Initiate a failover revert on the primary cluster
Nothing; this is an automatic process
Delete the primary clusters' snapshot of this data
Answer: A
QUESTION: 147
An Isilon customer created a scheduled SyncIQ policy to replicate data from an Enterprise-mode SmartLock directory. The source cluster becomes unusable. The target cluster does not automatically allow writes to the data in the replicated SmartLock directory. What is the most likely reason the target cluster did not automatically allow writes of the data into the SmartLock directory?
SyncIQ Automated failover is not supported for SmartLock directories; however, manual failover is allowed.
Automated failover and manual failover are not allowed on SmartLock directories on the target cluster.
A SyncIQ job was running while the source cluster became unusable, thereby removing all data in the target directory.
SnapshotIQ was not licensed on the target cluster; the snapshot of the directory is not available for use by SyncIQ.
Answer: A
QUESTION: 148
An Isilon customer has two 5-node clusters; one for production and one for disaster recovery (DR). The customer's workflows are replicated to the DR cluster through SyncIQ on individual schedules. They shutdown their production cluster for a scheduled DR test, failed over to the DR cluster, and continue their DR testing. Assume both clusters have identical shares, exports, and user authentication and
that the client applications have been stopped and the DNS re-pointed. What is the correct method to continue production operations?
Revert the SyncIQ Policy
Initiate Manual Failback of the SyncIQ Policy
Initiate Automated Failback of the SyncIQ Policy
No change to the SyncIQ Policy
Answer: A
QUESTION: 149
An Isilon customer has two 5-node clusters, one for production and one for disaster recovery (DR). The customer's workflows are replicated to the DR cluster through SyncIQ on individual schedules. They have shutdown their production cluster for scheduled maintenance, failed over to the DR cluster, and are currently operating from the DR site. Assume both clusters have identical shares, exports, user authentication, and that the client applications have been stopped and the DNS re- pointed. What is the easiest method to continue operations on production?
Initiate Automated Failback of the SyncIQ Policy
Revert the SyncIQ Policy
Initiate Manual Failback of the SyncIQ Policy
No change to the SyncIQ Policy
Answer: A
QUESTION: 150
How many file systems are present in a 20-node Isilon X200 cluster?
1
2
3
4
Answer: A
QUESTION: 151
Which type(s) of data is predominately associated with home directories and file shares?
E-mail files, PPT, Word documents
Oracle directories
SQL database files
XML data
Answer: A
QUESTION: 152
Traditional NAS storage architecture deploys simple two-way failover between two controllers in their storage systems, such as highly-available configurations. How is the Isilon architecture different in terms of system resiliency and availability?
Isilon OneFS enables each node to have a designated partner node for simple failover between the pair.
Isilon solutions can enable failover to other nodes with the use of client-side drivers.
Isilon clustered architecture deploys standby failover nodes to ensure the highest available solution.
Isilon OneFS enables each node to be a peer to any other node in an Isilon cluster.
Answer: D
QUESTION: 153
If a client is mounted to the sixth node in a 20-node Isilon cluster, how much memory cache can that client leverage assuming each node has 8 GB of memory cache?
16 GB
40 GB
120 GB
160 GB
Answer: D
QUESTION: 154
What is the maximum volume or aggregate size that can be created with an Isilon Scale-Out NAS system?
16 TB
100 TB
2.3 PB
20 PB
Answer: D
QUESTION: 155
Which Isilon product is recommended where low-latency and maximum performance is a critical factor?
X-Series
S-Series
SmartQuotas
NL-Series
Answer: B
QUESTION: 156
Refer to Exhibit below:
What is represented by the information shown in the exhibit?
A.
Directory quota cannot exceed 2 TB for both /ifs/data/media and
/ifs/data/media/photo. Directory quota cannot exceed 900 GB for
/ifs/data/media/video.
Directory quota can be any size up to 2 TB and each user can only store 75 GB for
/ifs/data/media/temp. B.
Directory quota cannot exceed 2 TB for /ifs/data/media and no quota limit on
/ifs/data/media/photo.
Directory quota cannot exceed 900 GB for /ifs/data/media/video.
Directory quota can be any size up to 2 TB and each user can only store 75 GB for
/ifs/data/media/temp. C.
Directory quota cannot exceed 2 TB for both /ifs/data/media and
/ifs/data/media/photo. Directory quota cannot exceed 900 GB for
/ifs/data/media/video.
Directory quota can be any size up to 2 TB for /ifs/data/media/temp. D.
Directory quota cannot exceed 2 TB for both /ifs/data/media and
/ifs/data/media/photo. Directory quota cannot exceed 900 GB for
/ifs/data/media/video.
Directory quota can be any size up to 900 GB and each user can only store
75 GB for
/ifs/data/media/temp.
Answer: A
User: Heitor*****![]() ![]() ![]() ![]() ![]() Thanks to Killexams.com, I never felt alone in my e20-555 exam preparation. Their practice tests and supportive educators helped me score 91%. Their materials were entirely valid and reliable. |
User: Mickey*****![]() ![]() ![]() ![]() ![]() I just passed my E20-555 exam with amazing marks, all thanks to Killexams.com. The questions were valid and correct, and I am so glad that I subscribed to their services. |
User: Yvan*****![]() ![]() ![]() ![]() ![]() Killexams.com truly delivered an excellent experience, providing comprehensive and accurate study material for my E20-555 exam. Their resources not only helped me pass with confidence but also allowed me to effectively test my knowledge and pinpoint areas where I needed to improve. I wholeheartedly recommend their study material to anyone preparing for the E20-555 exam. |
User: Lyubov*****![]() ![]() ![]() ![]() ![]() A friend recommended killexams.com when I decided to take the E20-555 exam to enhance my skills with E20-555 clients. Their demo impressed me, and the full study package, including an exceptional exam simulator, helped me excel. As a result, I became the new E20-555 supervisor at my workplace. |
User: Salomé*****![]() ![]() ![]() ![]() ![]() I found Killexams.com to be very helpful, and it made my e20-555 exam much easier. Thanks to Killexams.com, I passed the exam successfully and with a strong score. |
Features of iPass4sure E20-555 Exam
- Files: PDF / Test Engine
- Premium Access
- Online Test Engine
- Instant download Access
- Comprehensive Q&A
- Success Rate
- Real Questions
- Updated Regularly
- Portable Files
- Unlimited Download
- 100% Secured
- Confidentiality: 100%
- Success Guarantee: 100%
- Any Hidden Cost: $0.00
- Auto Recharge: No
- Updates Intimation: by Email
- Technical Support: Free
- PDF Compatibility: Windows, Android, iOS, Linux
- Test Engine Compatibility: Mac / Windows / Android / iOS / Linux
Premium PDF with 380 Q&A
Get Full VersionAll DELL-EMC Exams
DELL-EMC ExamsCertification and Entry Test Exams
Complete exam list